User Manual
Table Of Contents
- 1 Introduction
- 2 Features
- 3 Transceiver description
- 4 System and power management
- 5 Radio Peripherals
- 6 MKW2xDxxxV operating modes
- 7 MKW2xDxxxV electrical characteristics
- 8 MCU Electrical characteristics
- 8.1 Maximum ratings
- 8.2 General
- 8.3 LVD and POR operating requirements
- 8.4 Switching specification
- 8.5 Core modules
- 8.6 Clock modules
- 8.7 Memories and memory interfaces
- 8.8 Analog
- 8.9 Communication interfaces
- 8.9.1 USB electrical specifications
- 8.9.2 USB DCD electrical specifications
- 8.9.3 VREG electrical specifications
- 8.9.4 DSPI switching specifications (limited voltate range)
- 8.9.5 DSPI switching specification (full voltage range)
- 8.9.6 Normal Run, Wait and Stop mode performance over the fulloperating voltage range
- 8.9.7 VLPR, VLPW, and VLPS mode performance over the full operating voltage range
- 9 Transceiver electrical characteristics
- 10 Crystal oscillator reference frequency
- 11 Pin assignments
- 12 Packaging information
MKW2xDxxxV Product Electrical Specification, Rev. 0.1
60 Freescale Semiconductor
Slave mode
Figure 17. DSPI classic SPI timing — slave mode
8.9.5 DSPI switching specification (full voltage range)
The DMA Serial Peripheral Interface (DSPI) provides a synchronous serial bus with master and slave
operations. Many of the transfer attributes are programmable. The tables below provides DSPI timing
characteristics for classic SPI timing modes. Refer to the DSPI chapter of the Reference Manual for
information on the modified transfer formats used for communicating with slower peripheral devices.