User's Manual

WCT-5W1COILTX User Guide
Freescale Semiconductor 3
Figure-3 WCT-5W1COILTX charging the equipments
Others Indicates: when the Transmitter get the end power communication information, it will stop the
charging and wait until the RX is removed, under this states LED1 will be turned off, and LED2 will be
turned on all the time. When some fault found, the transmitter will turn off LED1, and turn on LED2 until
the fault is removed, fault include the FOD fault, OVP, OTP and so on.
4 Cautions
• This device has been tested and found to comply with the limits pursuant to Part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
• If this equipment does cause harmful interference to other electronic equipments, which can be
determined by turning the equipment OFF and ON, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the equipment
• Increase the separation
• In order to use the equipment safely，please don’t open the case when powered on，and don’t touch
the PCB and components with hand.
• Don’t place some metal things between the TX surface and the RX surface, otherwise the metal
things will be heated, it the temperature is too high, the Transmitter will shut down for protection.