User's Manual
Table Of Contents
- General Description
- Features
- Evaluation Kit Applications
- Revision Table
- Table of Contents
- List of Figures
- List of Tables
- Overview
- Installation and Setup
- Configuring Evaluation Kit Hardware
- Evaluation Kit Hardware Description
- PHY Evaluation Using the Wireless Developer Kit
- Summary List of Test Hardware and Software Required
- Equipment Handling
- Guidelines for Running Tests
- Transmit Spectral Mask Compliance Test
- Total Average Transmit Power Test
- Peak Envelope Power Test
- Receiver Sensitivity and Scaled Ranged Versus Throughput Tes
- Receiver Immunity Test
- Minimum Antenna Separation Test
- Penetration Test
- Video Transmission and Reception
- Operating Conditions and Characteristics
- Support
- FCC Compliance Statement
- License Agreement
- Warranty Disclaimer
- Glossary
- References
- Appendix A – Sources for Leasing of Test Equipment
Rev 1.34, June 2, 2004
Copyright © 2001-2004 Motorola, Inc. All rights reserved. Page 40 of 44
9. At the source transceiver run the following command in a terminal window to allocate a
stream to DEV 2:
./dme allocate_stream 2:2:3:4:5:6:7:8 2 31
10. At the source transceiver run the following command in a terminal window to map a
stream to DEV 1:
./dme map_send_stream 1 163 0 63 50 15000 -1
11. At the source transceiver run the following command in a terminal window to map a
stream to DEV 2:
./dme map_send_stream 2 162 0 62 50 15000 -1
12. At destination transceiver, DEV 1, run the following command in a terminal window to
map its receive stream:
./dme map_receive_stream 163 0 63 250000 1
13. At destination transceiver, DEV 2, run the following command in a terminal window to
map its receive stream:
./dme map_receive_stream 162 0 62 250000 1
Start the device(s) that will transmit an MPEG-2 stream via 1394 to the source
transceiver (depicted on the right side of Figure 11) so that it begins to transmit. For the
figure above, the camcorder or VCR will transmit on 1394 channel 63 by default. On the
Linux PC open a terminal window and use the sendfile command to read an HD file from
the hard disk and send it to the transceiver over the 1394 port.
./sendfile 62 filename 1 3
6. Operating Conditions and Characteristics
6.1. AC Power Consumption
The Evaluation Kit is supplied with an AC transformer that requires 100-240VAC as input and
draws 1.2 Amps.
6.2. Temperature Range and Humidity Conditions
The Evaluation Kit is meant to be operated between +10 degrees C and +35 degrees C ambient
air temperature under non-condensing humidity conditions.
6.3. IEEE 1394 Modes Supported
The transceivers support transfer of isochronous and asynchronous data. 1394 bus
enumeration is not supported. Only the devices listed in Table 5 have been tested and found to
operate with the Evaluation Kit.
Table 5: Consumer Electronics Devices
that Operate with Motorola UWB Transceivers
Manufacturer Model Number &
Description
Comment
Sony
Electronics
DCR-IP5 Camcorder
JVC HM-DH30000U VCR http://www.jvc.com/product.jsp?modelId=MODL026758
JVC HM-DH40000U VCR http://www.jvc.com/product.jsp?modelId=MODL027070