User Manual
Table Of Contents
- Revision History
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Wireless Sensing Triple Axis Reference design introduction
- Chapter 3 Sensor Board description
- 3.1 Board overview
- 3.2 A/D conversion of XYZ levels
- 3.3 Power management
- 3.4 ZSTAR Sensor Board hardware overview
- 3.4.1 Analog connections
- 3.4.2 g-select connections
- 3.4.3 BDM (Background Debug Mode) connections
- 3.4.4 Sensor Board schematics
- 3.4.5 Button connections
- 3.4.6 MC13191 to MC9S08QG8 microcontroller interface
- 3.4.7 MC13191 RF interface
- 3.4.8 Clocking options of MC9S08QG8
- 3.4.9 LED indicators connections
- 3.4.10 Power supply
- 3.5 Bill of Materials
- Chapter 4 USB stick board description
- Chapter 5 Software Design
- 5.1 Introduction
- 5.2 SMAC (Simple Media Access Controller)
- 5.3 ZSTAR RF protocol
- 5.4 STAR protocol and ZSTAR extensions (over USB)
- 5.5 Bootloader
- Chapter 6 Application Setup
- Appendix A References
Application Setup
Wireless Sensing Triple Axis Reference design, Rev. 0.9
60 Freescale Semiconductor
6.1.2 AN2295 Bootloader Drivers installation
This procedure assumes that ZSTAR Demo drivers are already installed. The drivers are alse common
for the bootloader (= are already present in Windows folders). If not, the procedure will be identical to the
ZSTAR drivers installation.
1. Press the Button on the USB stick and insert it into a USB connector (keeping the button pressed
when inserted).
The following window appears: