User Manual
Table Of Contents
- Revision History
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Wireless Sensing Triple Axis Reference design introduction
- Chapter 3 Sensor Board description
- 3.1 Board overview
- 3.2 A/D conversion of XYZ levels
- 3.3 Power management
- 3.4 ZSTAR Sensor Board hardware overview
- 3.4.1 Analog connections
- 3.4.2 g-select connections
- 3.4.3 BDM (Background Debug Mode) connections
- 3.4.4 Sensor Board schematics
- 3.4.5 Button connections
- 3.4.6 MC13191 to MC9S08QG8 microcontroller interface
- 3.4.7 MC13191 RF interface
- 3.4.8 Clocking options of MC9S08QG8
- 3.4.9 LED indicators connections
- 3.4.10 Power supply
- 3.5 Bill of Materials
- Chapter 4 USB stick board description
- Chapter 5 Software Design
- 5.1 Introduction
- 5.2 SMAC (Simple Media Access Controller)
- 5.3 ZSTAR RF protocol
- 5.4 STAR protocol and ZSTAR extensions (over USB)
- 5.5 Bootloader
- Chapter 6 Application Setup
- Appendix A References
Application Setup
Wireless Sensing Triple Axis Reference design, Rev. 0.9
62 Freescale Semiconductor
5. A similar setup should be observed:
6. Note down the COM port number (here, COM8); this is the port number of the Bootloader
Once the software in the USB stick needs to be updated, the Bootloader can be invoked anytime, just by
pressing the button while inserting the USB stick into the USB slot.