Installation Guide

Mounting the Transceiver in the NEMA Enclosure
LIG0002AC Rev G
l
1 - Mounting shoe
l
4 - #8 x 3/4 inch self tapping screws
Depending on your setup, it may be helpful to note the transceiver's serial number and any other information
needed from the transceiver's label. The transceiver snaps out of the mounting shoe if you need to access the
label information at a later time.
The mounting shoe is designed to securely grip the transceiver, allowing it to be mounted either horizontally or
vertically.
1. Secure the mounting shoe to the desired surface following the hole patterns and using the four self-
tapping screws provided.
Ensure the mounting shoe is oriented with the cut-away so that the front of the transceiver is
facing the required direction.
2. Snap the transceiver feet into place in the shoe, ensuring the front of the transceiver aligns with the
cut-away.
To remove the transceiver from the mounting shoe, push one of the locating ears outward and remove the
transceiver from the shoe.
Board-Level and Ruggedized Enclosure Din Rail Mounting Instructions
(MBRK-DIN-K)
The FreeWave MBRK-DIN-K Din Rail Mounting Bracket Kit is available to mount a board-level transceiver or
a transceiver in the light gray ruggedized or waterproof enclosure. The mounting kit ships with the following
hardware:
l
Rail guide
l
8 - 4 lock washers
6