Installation Guide
Table Of Contents
- About This Installation Guide
- Equipment and Tools Required for Installation
- Transceiver Installation Overview
- Choosing a Location for the Transceiver
- Installing the NEMA Enclosure
- Mounting the Transceiver in the NEMA Enclosure
- Powering the Transceiver
- Configuring the Transceiver
- Approved Antennas
- Installing the Antenna
- Cable Loss and Transmit Power Settings
- Waterproofing External Connections
- Board-Level and DB9 Pinouts
Mounting the Transceiver in the NEMA Enclosure
LIG0002AC Rev G
3. With the spring guide facing down and with the transceiver's RF connector facing up, attach the
transceiver to the rail by pressing the spring loaded guide onto the rail edge. Push the fixed guide
onto the other side of the rail.
The guides on the contact foot allow the transceiver to be installed vertically or horizontally on the
din rail mount.
Protective Mounting Bracket Kit Instructions (PMB-ENCL)
The FreeWave PMB-ENCL Protective Mounting Bracket Kit is available to mount a board-level transceiver
other than in a din rail system.The mounting kit ships with the following hardware:
8