Integration Guide

LIM0001AA Rev B (DRAFT)
Chapter 5: Troubleshooting
The main areas to address when initially troubleshooting a radio network are as follows:
l LEDs on the radio
l Radio Settings
l RF Quality
If you are experiencing trouble with a radio in you network, use the troubleshooting information available in this
chapter to help determine the issue. If you continue to have issues, contact FreeWave Technical Support.
Troubleshooting
My radio does not stay in Setup mode and I am not able to program it through the diagnostics port.
when I try to place the radio into Setup mode, all three LEDs flash green, and then go back to their
previous state.
Additional symptoms of this problem include:
Carrier
Detect
(CD)
Transmit
(Tx)
Clear to
Send
(CTS)
MultiPoint Master Solid red bright Solid red dim Off
MultiPoint Slave (unlinked) Solid red bright Off Blinking red
MultiPoint Slave (linked) Solid green Off Solid red bright
Point-to-Point Master (unlinked) Solid red bright Solid red dim Solid red bright
Point-to-Point Master or Slave Solid green Intermittent flash red Intermittent flash red
Two scenarios could be causing the radio to not enter Setup mode.
27
Draft