User's Manual

MM2 Wireless Data Transceivers
LIM0001AA Rev E
1. Plug a serial cable into the COM 1 port on the transceiver, connect the cable to a COM port on the
computer running Tool Suite, and connect the transceiver to a power source.
2. Open Tool Suite and select Setup Terminal in the Applications pane.
3. From the drop-down list at the top left of the window, select the COM port on the computer to
which the transceiver is connected.
4. Click Connect.
5. Place the transceiver in Setup Mode.
l Short Pin 2 to ground. For pin location, see "Embedded Radio Connector Pinouts" on page 3.
l If using a data cable (FreeWave part number: ASC3610DB or ASC3610DJ), press the Setup
button on the data cable.
If you are using the gray ribbon diagnostic cable (part number: AC2009DC), or the black
diagnostic cable (part number: ASC0409DC), the transceiver changes to Setup mode
automatically when you click Read Radio in Tool Suite.
All three LEDs on the transceiver light green and stay green as long as the transceiver is
in Setup mode.
As you navigate through the Setup menu and make changes to the parameters, the parameters are
sent to the transceiver immediately.
23