User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 5: Security
Configure Custom Service Settings
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Security menu, click Firewall > Custom Services.
The list of defined custom services is shown.
4. Do one of the following:
l Edit an existing Custom Service - Right-click an existing Custom Service and
click Edit.
l Add a new Custom Service - Click Add New Custom Service below the
Available Custom Services table.
5. Enter the Name of the service for identification and management purposes.
6. Select a Type option the layer 3 (network layer) protocol that the service uses.
7. In the ICMP Type field, enter the numeric value ranging between 0 and 40 for ICMP or
ranging between 1 and 255 for ICMPv6.
This field is visible when the layer 3 protocol (in the Type field) is selected as ICMP or
ICMPv6.
8. In the Port Type field, select whether the service covers a range of ports or multiple ports
not in a range.
9. In the Start Port field, enter the first TCP, UDP, or TCP and UDP port in a range or ports
that the service uses.
If the service uses only one port, enter the same port in the End Port and Start Port
fields.
10. In the End Port field, enter the last port in the range of ports that the service uses.
If the service uses only one port, enter the same port in the End Port and Start Port
fields.
11. Enter the Ports this service supports separated by commas (,).
This field is visible when the Multiple Ports option button is selected.
12. Click Save to save the changes or Cancel to clear any changes without saving.
Delete an Existing Custom Service
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
Page 104 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.