User's Manual

WavePoint 10e
3. On the Administration menu, click Users > Groups.
The list of user groups is shown.
4. In the Groups List, right-click the group to delete and click Delete.
Delete all User Groups
Note: All user groups except the factory defaults are deleted.
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Administration menu, click Users > Groups.
The current list of user groups is shown.
4. In the Groups List, right-click any group name and click Select All > Delete.
Adding and Editing Users
Each person that accesses the WavePoint 10e has a user login with a User Name and Password.
Prior to adding users, the Group that defines the user access privileges must be defined. See
Adding and Editing User Groups.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Administration menu, click Users > Users.
The list of users is shown.
4. Do one of the following:
l Edit an existing user - Right-click the user name in the table and click Edit.
l Add a user - Click Add New User below the user table.
5. Enter the User Name (e.g., Technician).
6. Select the Group to assign the user to.
Note: Groups determine the login privileges for the user.
7. Enter the User Name.
LUM0063AA Rev 05/05/2014 Page 129 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.