User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l CN=<device name> (Example: CN=router1)
l OU=<department>
l O=<organization>
l L=<city>
l ST=<state>
l C=<country>
7. Select either Hash Algorithm:
l MD5 to produce a 128-bit hash value.
l SHA-1 to produce a 160-bit hash value.
Note: The network and the installation environment determines the hash
algorithm needed.
8. Select the Signature Key Length in bits.
Larger key sizes may improve security, but they can also decrease network
performance.
9. Optional: Enter an IP Address to customize the certificate request.
10. Optional: Enter a Domain Name to customize the certificate request.
11. Optional: Enter an Email Address of a contact at the company that can answer questions
about the request.
12. Click Save to save the changes or Cancel to clear any changes without saving.
The WavePoint 10e generates the certificate request and is listed in the Self Certificate
Requests table.
13. In the Self Certificate Requests table, right-click the certificate and click Edit.
14. Copy all the text in the Data to Supply to CA field into a TXT file and save the text file.
15. Submit the certificate request to a CA including the information in the text file and any
other information required from the specific CA.
16. When the certificate is received from the CA, it can be uploaded as an active self
certificate.
See Adding Active Self Certificates on page 141.
Adding Active Self Certificates
When a self certificate is received from the Certificate Authority (CA), the certificate is uploaded to
WavePoint 10e as an active Self Certificate.
LUM0063AA Rev 05/05/2014 Page 141 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.