User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 7: Diagnostics and Troubleshooting
l Close and reopen the browser.
l Try using an alternate browser (e.g., Firefox, Chrome, etc.)
l The correct login information is used.
l The factory default User Name is admin and the Password is freewave.
Both are case sensitive.
Verifying the IP address of a Windows® Computer
1. Open a Windows Command Prompt.
2. Issue the command ipconfig.
3. Check the Local Area Connection for:
l IPv4 Address.
l Subnet Mask.
If IP address does NOT reside within the same subnet (see example) change the
computer’s IP address to reside within the same network.
Example:
Computer: 192.168.150.3/255.255.255.0.
WavePoint 10: 192.168.1.100/255.255.255.0.
To configure the computer to reside within the same subnet the correct IP
address is 192.168.1.3.
4. Use any unique address within the range that is NOT currently used.
Configuration Changes are not Saving
l Click Save in the current page before moving to another page.
l If you navigate to another page without clicking Save, any changes made on that page
are lost.
l Refresh the web browser window.
l Changes may have been saved but the browser could be caching the old configuration
and not updating the new settings on the web page.
WavePoint 10e cannot Obtain an IP address from the ISP
1. Turn off the power to the cable or DSL modem.
2. Turn off the WavePoint 10e.
3. Wait 5 minutes, and then turn on the power to the cable or DSL modem.
Page 148 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.