User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
Appendix D: Bench Test Verification of
WavePoint™ Configuration
Important: For successful replication of this test for a 2.4GHz WavePoint™, the
Required Materials are needed. Where noted, these materials can be ordered from
FreeWave.
Required Materials
Qty Description
1 1 foot RF SMA cable
2 20dB SMA attenuators
2 TNC > SMA couplers (FreeWave Part Number: ECN0313TS)
2
2.4GHz whip stub antennas (FreeWave Part Number: EAN2400SR)
900MHz whip stub antennas (FreeWave Part Number: EAN0900SR)
Note: 5GHz antennas are not available from FreeWave.
RF Cabled Test Procedure
1. Connect a laptop to the WavePoint 10e using an Ethernet cable connected to Ethernet
port 3 or 4.
2. Connect an RF cable between the WavePoint™ devices.
3. Use attenuators to establish 40 dB of attenuation.
4. On the laptop, open a web browser.
5. Navigate to the WavePoint 10e default IP address (192.168.1.1).
The WavePoint™ Login window opens.
6. Enter the admin Username and Password.
7. On the Wireless LAN menu, click Radios > Advanced.
The Advanced Radio window opens.
8. In the Radio table, select the radio to change the power settings and right-click.
9. On the right-click menu, select Edit.
The Advanced Radio Configuration dialog box opens.
LUM0063AA Rev 05/05/2014 Page 157 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.