User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l Administrator - Can view and change all configuration settings.
l Guest - Can view configuration settings but cannot save changes.
Connect WavePoint 10e to a Computer
Important: Initial setup requires a wired connection.
1. Verify the WavePoint 10e has power.
2. On the WavePoint 10e Connector Panel, connect a CAT 5e Ethernet cable from
Ethernet port 3 or 4 to a computer that has a web browser installed.
Note: Use a command line to ping 192.168.1.1 to ensure the WavePoint™ is ready for
use.
Important: For 2.4 GHz WavePoint 10e devices, connect to a wireless connection
after the WLAN settings are configured.
3. On the connected computer, open a web browser.
4. In the web browser's navigation bar, enter http://192.168.1.1.
This is the WavePoint 10e factory default IP address.
Note: If the IP address was changed, enter that IP address in the navigation bar of the
browser to access the Configuration pages.
5. Enter the default User Name (admin) and Password (freewave).
User Names and Passwords are case sensitive.
Login Type Default Login Credentials
Administrator
Username: admin
Password: freewave
Guest
Username: guest
Password: freewave
Note: If the User Name or Password has changed, use the updated information
in the appropriate fields.
6. Click Login to view the Configuration pages.
7. Optional: See the Setting the Device IP Address and Subnet on page 38 procedure to
change the subnet address.
LUM0063AA Rev 05/05/2014 Page 33 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.