User's Manual

WavePoint 10e
Searching for Menus 35
Chapter 2: Configuring Basic WavePoint™ Network Features 37
Setting the Device IP Address and Subnet 38
IPv4 Networks - Set the IP Address and Subnet 38
Reserved Subnets 38
Enabling and Configuring DHCP 39
IPv4 Addressing - Enable and Configure DHCP 39
Reserving IP Addresses 41
Reserve IP Addresses in an IPv4 Network 41
Delete a Specific LAN Reserved IP Address 41
Delete all Reserved IP Addresses 42
Using Multiple WANs or a Single WAN 42
Indicate the Number of WANs in Use 42
Configuring the WAN in an IPv4 Network 43
Defining WAN Connections Using Static IP Addresses 43
Defining WAN Connections Using DHCP 44
Defining WAN Connections Using PPPoE 45
Defining WAN Connections Using PPTP 46
Setting the Device Mode 47
Chapter 3: Additional Data Networking Features 49
Defining Physical WAN Port Settings 49
Setting Up Auto Fail-Over in Multi-WAN Environments 50
Balancing Data Flow in Multi-WAN Environments 51
Restricting the Traffic Type for Each WAN Port 52
Configure a Traffic Restriction (Protocol Binding) for a WAN Port 53
LUM0063AA Rev 05/05/2014 Page 7 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.