User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
6. Click Save to accept the change and close the dialog.
The Parent Selection Profile window returns showing the accepted Selection Method
assigned to the device.
Parent Selection Profile window with a successful Branch WaveMesh
LUM0063AA Rev 05/05/2014 Page 71 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.