User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
9. Optional: In the Follow Schedules field, select a schedule from the list if schedules were
defined.
10. Click Save to save the changes or Cancel to clear any changes without saving.
11. On the Wireless LAN menu, click Radios > Advanced.
The Advanced Radio table lists the radios available in the device.
12. Right-click the radio to configure and click Edit.
13. Complete these fields described in Defining Advanced Radio Settings on page 85:
a. Mode (Modulation Scheme)
b.
Channel
c.
Channel Width
d.
Distance
There are additional fields available in the Advanced Radio settings that
are not required for basic setup but that may be helpful.
14. Click Save to save the changes or Cancel to clear any changes without saving.
Defining Advanced Radio Settings
When initially setting up a WavePoint 10e for wireless communication, review the settings in the
Wireless LAN > Radios > Advanced page to ensure the parameters are set to meet the needs of
the network. The Channel and Channel Width fields should match across radios that
communicate in the network.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Wireless LAN menu, click Radios > Advanced.
4. Right-click the radio in the table to change and click Edit.
Radios are labeled 1, 2, 3, and 4.
The label on the back panel of each WavePoint 10e identifies what type of radio is
installed and which number corresponds to each installed radio.
LUM0063AA Rev 05/05/2014 Page 85 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.