User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 5: Security
This chapter discusses these options for securing the traffic in the network:
l Firewall setup including policies, rules, and scheduling.
l RADIUS server setup.
Firewall Overview
Inbound rules govern access from the WAN to the LAN. Using firewall rules allows only specified
local resources to be accessed from the Internet.
By default, all access from the Internet is blocked from accessing the secure LAN, except in
response to requests from the LAN. Outbound (LAN to WAN) rules restrict access to traffic leaving
the network, selectively allowing only specific local users to access outside resources.
Firewall Basic Policies
Default Outbound Policy
This configuration determines whether LAN users can access the Internet in the absence of specific
allowed outbound rules.
Use Allow Always as the default outbound policy to permit any outbound traffic to
pass through the firewall and reach the WAN.
LUM0063AARev 05/05/2014 Page 99 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.