User's Manual

3. Configuring the WP201-100
Page 53 of 267 LUM0073AA Rev Feb-2017
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Figure 53: Wireless window - Fast Handover, Management VLAN Settings,
and Cross Band VLAN Pass Through areas
15. In the Fast Handover area:
a. Select the Enable option button to activate the Fast Handover feature in the WP201-
100.
b. In the RSSI text box, enter the Received Signal Strength Index (RSSI) to determine
when the handover procedure terminates the current wireless link.
16. In the Management VLAN Settings area:
a. Select the Enable option button to assign a VLAN tag to packets sent over the network
or to access a computer with the same VLAN tag.
b. In the Management VLAN text box enter the VLAN tag number.
17. Click the Cross Band VLAN Pass Through list box arrow and select Enable to allow
VLAN traffic on either band to pass through a network.
18. Click Save to save the changes.
The Wireless window refreshes.
The Changes tab shows the accumulated number of pending changes ready to apply.
Figure 54: Changes tab showing the number of changes to apply.
19. Click the Changes tab.
The Unsaved window opens.
Important!: The change count and the changes listed in the image are examples only. The list
identifies different information depending on the changes applied to the WP201-100.
DRAFT