User Manual
Airplane Pushrod Size
Flap pushrod size
Aileron push rod size
Elevator push rod size
Rudder pushrod size
1
Air-b
rake Installation
Step4
T-45 Goshawk
3 3
3 3
1.Put the"Screw(B)"into the"Ball head(A)",
then insert "Screw(B)"into the hole of the
"Control horn(D)" and lock it into place using
"Nut(C)"
1.
Thread the "Ball head clevis (B)"onto the
threaded end of "Pushrod (A)". Twist left or right
to increase or reduce the length of the pushrod.
2.
Feed the angled side of the push rod into the
servo arm. Then place the second part of
"Plastic lock(C)" over the "Push rod (A)" and
snap the "Plastic lock(C)" to the push rod to
lock the pushrod in place.
Flap push rod mounting hole
Aileron push rod mounting hole
� !
Elevator push rod mounting hole
r
Rudder pushrod mounting hole
Step 2
Accessories
A
-
Air-brake mount
B
-
Air-brake pin
C
-
E-clip (01.5mm)
D
-
Air-brake
E
-
Servo
(9g
-MG
)
Step 3
1.
Follow Step 1 to assemble the air-brake.
2.
Use glue to attach the servo.
3.
Use glue to attach the air-brake to the fuselage.
4.
Use the push rod to connect the air-brake to the servo
arm. Set up the open angle of the air brake by adjusting
the pushrod length.
(After setup, pay attention when cycling the air-brake. If
the servo makes a buzzing sound, increase the open
angle until it cycles silently.)
Air-brake push rod size
Air-brake push rod installation hole
-6-