introduction Thanks for your purchasing our Freeing F-22 jel. it used EPO material with very scale appearance, and iis scallion control performance and flight performances, is suitable for the jot beginner players This F-22, ali the control surface we used the modular design, it can be very convenient Tor installation and carry in outside. AN NOTE: This is not a toy. Net for children under 14 years.
installing rear landing gear Remove theses accessories Alright landing gear Berra landing gear fixed part C-scow ass ape 1. Install left / right landing gear (A) on the indicated position of fuselage. 2. Cover rear landing gear fixed part{8). A\Note: please check the plastic part "L” “R” Ark. Plastic part should distinguish left/right to shack ia install position, 3.Fixed the landing gear by screws {C}. 4.Finish to install as the right photo shown.
installing nose landing gear When you ends to disassemble/assembls the nose landing gear, please refer to the following structure. Accessories list & name A-wheal B“L° nose landing gear wire C-nose landing gear decorated part D-lockout mes tp) E-sons landing gear mount F-nose landing gear wire connecting post G~ Jim screw woes 20 H-serve [-aerie Swazis pus} J-arm of servo steering K-801vo 8 Crew (wars pox L“U° nose landing gear wits. #2.0mm mm Beam 3mm 1.insert wheal{A} into "L” nose landing gear wiring. 2.
installing the Wing 2. Cannect the servo wire {D} and extension wire in fuselage(F}. 3. insert left wing{A) into fuselage. and we should pay attention of following: fingertip carbon tube in wing(E) to the carbon tuba{F}. ~Insert plastic parts in wing (G) ta the plug in fuselage. 4. Through plastic pairs in wing {G}, fix the wing by apes screws (CL &.rigs the mass way io install the right wing. een (PATS Apes) installing the Wing's servo if you purchased KIT version, please refer fo the following to install.
installing the Elevator 1.Remove these accessories A-frightful elevator B-sower (pr174 apes) 2.Insert left/right elevator (A1,A2} fo the horizontal tall holder {C) of fussiness. 3.Fix the valorous by SBA TT installing the Elevator's servo If you purchased KIT version, please refer to the following to install. 1.Firstly, we need {o be center the serve arm through radio or servo tester. 2.Attach the elevator servo box (Aron the fuselage. 3.Connect extension wire (C } and servo wire.
Installing the Rudder 1. Remuve these accessories rudder Screw (PAS pus) 2 insert left/right rudder (A1, AZ} te the fuselage. 3. Reverue the fuselage and rudder together, put on the rudder screw fixed part{C). 4 Fix the rudder by PCs screws {B). install on battery Lift up aps, i removes canopy Battery Our standard battery is Lift up taps, it removes canopy, then bundled 38 11.1V 1800mAh Z5C or 4S 14.8V 1600mAh 25C battery with Ravel.
Assemble EDF and Motor 7.Put the assembled EDF {J} into fuselage. 1. Assemblies motor {A} to the motor mount (8). 2.Fix the motor{A) by screws{C). 8.Connect ESC and motor and sort oul the wires of ESC 3.Insert the collided) into motor shaft. and motor, 4.5¢1 backpacker} into the collected. 8.Cover the EDF cabin cover(l) 10.Fix it by poss screws{H). 5.8et the fan {F) into the collected. crewel the decollete) by nutting) to fix the fan (F).
Center of Gravity Carr act nectar of gravity is directly related to the success of the flight, please refer to the following CG diagram to adjust your plan's center of gravity. 83 ~ 88mm {3.27 ~ 3.47 in) Charger Safe Use Xi You must first charge your flight battery before flying. Plug the charger info a 220V wall outlet. This charger can ba used with 2 and 3 cell lip batteries. The F-22 uses a 3 cell Li-PO battery. The battery comas with two less of wires and connectors.
Radio control Direction 1. Radie Include the transmitter and revolver. 2. Radie function introduction {Mode 2} LED Lights Theodore Maa Elevator down nets: Susie : had Throttles Min Elevator up Aileron = Gh Elevator =» Ch Throttle Ghd Rudder: w Ghd Landing Gear. »ChS Flaps CHE 7 1.Gear Switch ¢ S.Power Indicator 2.Flap Switch + 8. Dslta B.D/R For stein 7. Raverse 4. Trim 8. Nackstrap Attachment Sets: The factory have bind the sierra and transmitter, you can use directly.
Control surface direction and set up Afar Installed the plans, before flying, we need a fully charged battery and connect to the ESC, then use radio to {ast and check that every control surface work properly. Aileron Stick Left Tick Right Elevator Up Elevator Down Elevator %, Rudder Stick Left Stick Right Dual Rates According to our testing experience, refer to the following parameters to set up control surface rate, it will be useful for your flight.
Troubleshooting Guide Rotor does not turn on A) Li-Po bestiary depleted A) Chargers Li-Po battery B) Transmitter batteries depict B) Replace or recherche batteries ©} Transmitter not turned an ©) Turn on transmitter 1D) Li-P battery not plugged in E) Mo tar not armed F} Crash has damaged an internal component G) ESC or offer damaged D) Plugin Li-Po battery E} Asm miter F} Replace ©) Hack ESC or contact local distributor Cub is difficult fo control A) You are fining In tac much wind A) Fiy when there is no w
Accessories list support fine | Predicament Anticipation nit Morse.
