User Manual
Nose landing gear door installation
Nose landing gear door accessories list
1. Install the metal ball head on the "nose gear door 1 (A)".
2.Use "metal wire (C)" to connect the "nose cabin door
1 (A)" and "nose cabin door 2 (B)". then bend the end
of "metal wire (C)" to secure it.
3.Put one side of "Spring (D)" into the hook on nose
gear door 1 (A),the other side to the hook of "nose
gear door 2 (B )".
4:Secure the rotating arm at the bottom of nose cabin door
2 (B) and snap it into the "gear door installing mount
(F)".
5.Finally snap the clevis side of " push rod (E)" into the
metal ball head of"nose gear door 1 (A)", and snap the
other side into the nose gear door fixed plastic part.
After installation, test the retraction/
deployment of the gear door. Adjust the length of "metal
wire (E)
"
, to achieve the best results.
Nose steering control accessories list
A- Servo
B - Servo plastic anchor
C - Screw (PWA1.7x5mm)
0 - Screw (PWA1.7X5mm)
E - Screw (PM3>6mm)
F - U-shaped servo arm
G-
Screw (PWA2.0>8mm)
H-
9g servo installed set
I-
Nose steering push rod
J-
Nose landing gear steering control ring
F-86 Sabre
�
IG
g
-7-
EN
E
I
C
1
1
'
t
D
Refer to the diagram at the right and attach the
servo to the plastic anchor.
Use 2 screws (G) to mount this assembly to the
fuselage.
Feed the pin on the steering control rod through the
eye of the nose gear steering control ring and snap
it to lock it.
Insert the open end of the control rod through the U
shaped servo arm (F).
Adjust the nose wheel so that it is centered and lock
the control rod down using screw (E)