Note Product basic information Package list PNP Assembly instructions install horizontal stabilizer install vertical stabilizer Install main wing install nose cone Install battery Push rod instructions Important additional notes Center of gravity PNP Parameter setting Control direction test Dual rates Pr-installed component overview Servo direction Motor specification FUEHRER FER HAE SH WILDFIRE PALE LBA FRAN TARE ERB HL Ea [cine BEERS RT TEEN BEET HARE PNP A BEE FRE TR TREE BEER HEE
1.This is not a toy] Ops rater should have a certain experience, beginners should operate under the guidance of professional players. 2 Before install, pleases read through the instructions carefully and operate strictly under instructions. 3.Cause of wrong operation Freeing and ifs vendors wil not be held responsible for any losses, 4 Model planes’ players must be on the age of 14 years old. 5.
Ag the photo show Anne Be traction steel wire from the battery 2 uss the traction tiles! wire i pull the servo table ang install the horizon toll stabilizer on tha fireplugs fail 3:Use docs screws to fix the horizontal stabilizer. Serendipitous GI ARO As the photo show | parting the traction steel wire from tha battery compartment the tail 2 Lge the traction seal wire bs pull the serve cable back, and Install the vertical stabilizer on the fuselage fil.
As the photo show © {Install tha main wing on te fuselage and Use poss screws to ix.
Cantor of Gravity Correct Canter of Gravity (PCG) Is critical for enabling safe aircraft stability and responsive control. Please refer to the following CG diagram to adjust your rafter's Center of Gravity. Depending on the capacity and weight of your choose flight batteries, move the battery forward or backward to adjust the Canter of Gravity. If you cannot obtain the recommended CG by moving the battery to a suitable desiccation, you can also install a counterweight to achieve correct CO.
ddl Ed After installed the plane, before flying, we need a fully charged battery and connect te the ESC, then use radio fo test and check that every control! surface work properly.
