Introduction Thank you for purchasing F-15 "Eagle" 20mm EDF jet! From the mid-1970s into service, F-15 has become the world's most respected once air superiority fighter, the McDonnell Douglas F-15 "Eagle" is impressive main USAF air superiority fighter . This 1:13 scale F-15 90mm EDF Jet Is the best proportion which slut for 80mm EDF Jet.
Product basic information 1450 mm (577) Wing load : 209g/dm? Motor: O/R BL 3748-1550KV Servo: 9g/17g MG servo (4/8pcs} ESC: 130A with 8A CUBE Dusted fan; 90mm 12-blade fan Weight: 3080g (w/o Battery) Thrust: 3600g Wing load : 214g/dm? Motor: I/R BL 4068-1680KV Servo: 9g / 17g MG servo ESC: 130A with 8A CUBE Dusted fan: 80mm 12-blade fan Weight: 3200g (w/o Battery) Thrust: 4200g General function -Retract landing gear controlled by electric worm -Front,rear landing gear cabin door (4/8pcs) f———965 mm —| -Scal
Installation Screw (PAT sexism PCs) Sara cover Serra box Hom Push rod Servo cable trough 1. Use servo tester or radio to center the servo Motown» arm. 2. Use glue to attach the 17g servo box (C) and hom {D) on the main wing. 3. Install the servo on the 17g servo box (C), and press the servo cable on the servo cable trough (F), cover the 17g servo cover (B), and use PCs screws (A) to fix the servo. 4. Use Push rod (E) to connect the servo arm and rudder horn (D). lle Push rod diameter : & 1.
Installation {i Install ale-brake Please refer to the following photo, install/replace/revise air-brake. Spare part name and specification A-Pin (23 558 prom} E-Screw (PTZ 8xsmm Zp) B-Connect arm 1 F-Air-brake C-E-buckle mm} G-Al-brake fixed plastic part D-Air-brake slant rod H-Plastic rotating shaft | -Screw (PWadximm Apes} J -Al-brake controller K-Screw (FM2x18mm poss) L-Nut {simmer apes) M-Blister cover el i Install nose cone, missiles, pylons.
Installation Decal position We provided a decal In package. Please refer to the following photo to stick the decal on fuselage surface. Ticked the decal, your Jet will looks more beautiful and scale.
Install landing gear Nose Landing Gear Assemble Please assemble, disassemble the nose landing gear according to the following photo. Accessories name and specification A-Refract controller H-Nose gear main supporting rod ~~ O-Screw (FAZsgmm apes) V-Pin B -Nose gear main rod | -Screw (Paz=dmm pes} P-Rhea! {#451 8mm} W-E-buckle (Ff.
Install landing gear Rear Landing Gear Assemble Please assemble, disassemble the rear landing gear according to the following photo.
Control direction test After installed the plane, before flying, we need a fully charged battery and connect to the ESC, then use radio to test and check that every control surface work properly. Aileron ‘Stick Loft i Stick Right Elevator Up Elevator : 3 Down Elevator.
Dual Rates According te our testing experience, according to tha following parameters to set the alleron/elevator rate, It will be useful for flight. In low rate, its good for flight control and its suitable for the initial flight or less skilled players. According to your own circumstance, choose ona rate in flight.
