Maintenance Manual

Maintenance Operation Sets
Maint.
No.
Operation Description
Service Schedules I
and II
IM M1 M2 M3
42–05 Brake Inspection ••••
42–06 Haldex Slack Adjuster Lubrication • • • •
42–07 Meritor Camshaft Bracket Lubrication • • • •
42–08 Meritor Slack Adjuster Lubrication • •
42–09 Bendix E–6 Foot Control Valve Inspection and Lubrication •
42–10 WABCO System Saver Air Dryer Desiccant Cartridge Replacement
§
••••
42–11 Versajust Slack Adjuster Inspection and Lubrication
¶
•••
42–12 Bendix Automatic Drain Valve Operating and Leakage Tests
**
••
46–01 Drag Link Inspection ••
46–02 Power Steering Fluid and Filter Change •
46–03 Power Steering Fluid Level Inspection • •
46–04 Drag Link Lubrication ••
47–01 Fuel Filter Replacement •••
47–02 Fuel/Water Separator Element Checking and Replacement • • •
47–03 Fuel Tank Band-Nut Tightening •
49–01 Exhaust System Inspection (noise emission control) • • • •
54–01 Trailer Cable Inspection and Cleaning • •
60–01 Mirror Folding Check ••
60–02 Cab Shock Absorber Bracket Torque Check • • • •
60–03 Aerodynamic Component Inspection • • • •
60–04 Baggage Door and Sleeper Access Door Release Cable and Latch Lubrication • •
83–01 Air Conditioner Inspection ••
83–02 Air Filter Replacement ••
83–03 Battery-Powered HVAC System (BPHS) Inspection • • • •
*
On vehicles equipped with Detroit transmissions, the release bearing does not need to be lubricated. On vehicles equipped with Eaton Fuller UltraShift PLUS
transmissions, lubricate the release bearing every 50,000 miles (80 000 km) or 3 months.
†
For Eaton Fuller transmissions, fluid change intervals are extended to 500,000 miles (800 000 km) on vehicles filled with synthetic transmission fluid.
‡
For Schedule I vehicles with Detroit axles, complete this procedure once a year or every 25,000 miles (40 000 km), whichever comes first.
§
If equipped with an oil-coalescing desiccant cartridge, replace the cartridge once a year, regardless of mileage. Otherwise use the M3 maintenance interval.
¶
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
**
The automatic drain valve should be inspected every 6 months or 1500 operating hours, whichever comes first.
Table 8, Maintenance Operation Sets
General Information 00
Maintenance Operation Sets Table: 00–08
New Cascadia Maintenance Manual, October 2020 00/13