Installation Guide

2
Installation
Hot switch valve(Red)
O-ring
Plate washer
Fixing washer
Round screw
Fixing nut
Supply Lines
Three way connector
Faucet
Rubber washer
Cold switch valve (Blue)
Fit the rubber washer into the bottom groove of the faucet, place the faucet into the installing hole on
the countertop.Place the plate washer and fixing washer under the countertop and revolve the fixing
nut.Check that the faucet is correctly positioned,then tighten the round screw .Screw the three way
connector(make sure a plate washer inside) onto the bottom thread of the faucet.
Install the supply lines attached hot switch valve (Red) and cold switch valve (Blue) into the installing
hole on the countertop.Turn the hot switch valve in clockwise direction and cold switch valve in
anticlockwise direction to off state.Place the plate washer and fixing washer under the countertop
and revolve the fixing nut. Adjust the position of the two valves and keep the handle in the same
direction as the diagram, tighten the round screw .
Screw one end of the supply lines to the thread on the hot and cold switch valve. (See the above
diagram)
Screw the other end of the supply lines to the thread on the three way connector.(See the above
diagram)
1.
2.
3.
4.