Installation Guide

2
ALLEN
KEY
FAUCET
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
GRUB
SCREW
CAP
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
Installation
Faucet
Supply lines
Male screw
Washer
Rubber washer
Brass washer
Female screw
1: Twist supply lines into faucet. washer into the groove of faucet.
2: Pass supply lines through the countertop hole, fix the male screw to the faucet.
3: Pass the rubber washer and brass washer to the male screw, adjust the faucet and tighten the female screw.