FMCO012436/013036/013636/014836 ® MEDICINE CABINET INSTALLATION GUIDE FRESCO IMPORTANT SAFETY INSTRUCTIONS When using an electrical furnishing, basic precautions should always be followed, including the following: £m | READ AND FOLLOW ALL DANGER | INSTRUCTIONS BEFORE | USING THIS CABINET. WARNING To reduce the risk of burns, fire, electric shock or injury to persons. Use this furnishing only for its intended use as described in these Instructions. Do not use attachments not recommended by the manufacturer.
FMC012436/013036/013636/014836 ® MEDICINE CABINET INSTALLATION GUIDE FRESCOES TOOLS REQUIRED FOR ASSEMBLY FA 1/8" Drill Bit Single j ” Double Door LL Door Cabinet i Cabinet Top Shelf Clip ; Bottom Screw Cap Hole Plug Mounting 12 Mounting $0514) S05 Bracket Ly Bracket Hinge Screw BE Glass Shelf Glass Side Panel [ey jos © FMC012436/013036/013636/014836 | INSTALLATION GUIDE #2018 FRESCA™ All rights reserved, This material may not be reproduced, displayed, modified or distributed without the express prior writt
FMCO012436/013036/013636/014836 MEDICINE CABINET INSTALLATION GUIDE 9, © FRESCO 24" Ellie le), ot & Goa 30” A Cabinet's Width B Cabinet's Height € Cabinet's Depth & Lt ZG" NOTE: Determine overall medicine cabinet dimensions. If recessing medicine cabinet, determine rough-in dimensions. 225" x 34.4" 28.4" x 34.4" 34.4" x 34.4" 461" x 34.4" “All dimensions & specifications are approximate and subject to change without notice.
PRIOR TO MOUNTING: ILLUSTRATION 24 © FMCO012436/013036/013636/014836 | INSTALLATION GUIDE ©2018 FRESCA™ All rights reserved. This material say not be reproduced, displayed, modified ar distributed without tha harass prior written pianissimo of the copyright holder.
FMCO012436/013036/013636/014836 ® MEDICINE CABINET INSTALLATION GUIDE FRESCO ELECTRIC CONNECTIONS ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENSED ELECTRICIAN WARNING: shut off power before wiring the cabinet. WARNING: An Electrical option cabinet must be wired to a 20 Amp GF! (Ground Fault interrupter) protected circuit when used in bathrooms and all other locations required by the National Electric Code.
Draw the parietal of the medicine cabinet on the wall. Glossiness BU LH RE age Cut the marked perimeter with appropriate tool Level, then secure the medicine cabinet with the screws through the mourning holes into the framing studs, Frame the cutout opening. {Sea illustration below) Place and hold the medicating cabinet in the cutout opening: 4 STEPS TO FRAME THE CUTOUT OPENING Choose the position for your shelves, then push and twist the snap-in pins into place. a. &.
SURFACE-MOUNT INSTALLATION Cleveland mark the medicine cabinets location on the wall from point ato point IMPORTANT: Boston mounting brackets must be attached to furring strip/channel or wall studs. Attach bottom Laval and mark. bracket (E} to insert top mounting bracket {D) into the top of the cabinet (A). With assistance, rest the medicine cabinet (A) on the bottom mounting bracket {E} and hold it in place. IMPORTANT: Top mounting brackets must be attached to furring strip/channel or wall studs.
SURFACE-MOUNT INSTALLATION NOTE: For more details on the shelf installation please refer to Page §, Step 7. Connect the glass shelves (C) to the cabinet by pushing the side of the shelf in the left or right clip and snapping the shelf down. IMPORTANT: Top mounting brackets Slide top brackets into channel! Make sure top brackets are must be attached to furring at the top of the cabinet. locked in the grooves. strip/channel or wall studs.
FINAL ASSEMBLY Plug the door into the cabinet. EY Insert clear snap in shelf hs. Push the side of the shelf Ae, insert clear plugs (4) into the clips (F} into holes on the in the left or right clip and remaining or unused holes, then cover sides of the cabinet (a). snap the shelf {C3} down, screw heads with the screw cups (6). & 2 © FMCO012436/013036/013636/014836 | INSTALLATION GUIDE ©2018 FRESCA™ All rights reserved.
FINAL ASSEMBLY How to use Defogger Switch and Dimmer Switch: Touch the Defogger switch to turn the heating coils on or off. Touch the Dimmer switch to turn the task light on or off. Press and hold the dimmer switch to dim or brighten the task lights. Dimmer switch stores the current light level intensity when switched off and on.