Installation

ManualsBrandsFresca ManualsBathGeona Brushed Silver 3-Jet Shower Panel

FSP8009

GEONA

INSTALLATION GUIDE

Please unpack and inspect all packages and components carefully,

make sure they are complete. Examine for shipping damage. If some

parts are damaged or missing, notify your dealer immediately.

Before assembly, ﬂush the water

supply pipes thoroughly to

remove debris(allow the water to

run with the main stopcock open

for about 3 mins), otherwise dirt

particles might affect the function

of the shower panel!

Note!

PAGE 1

Parts List

For lnstallation Yon may Require

Summary of content (5 pages)

PAGE 1
FSP8009 GEONA INSTALLATION GUIDE Parts List Please unpack and inspect all packages and components carefully, make sure they are complete. Examine for shipping damage. If some parts are damaged or missing, notify your dealer immediately.
PAGE 2
Dimensions Back View Choose a suitable place to install the shower panel, adjust the shower panel’s vertical position based on the user’s height and your sanitary room. Usually, install the panels at the distance of 82 3/5" from the top to the ground, but you can assemble according to your instance.
PAGE 3
Your item may appear slightly different from the illustration Note! Before drilling any holes for ﬁxing your shower panel ensure that there are no hidden cables or pipework within the wall.
PAGE 4
to the “Fresca”outdoors shower panel series. F95F 0.4 F 86 F113 F10 Note! The shower panel is for indoors use only. For outdoors use please refer Thermostatic Control 122 Don’t forget to place the rubber washer when it is necessary.lt will avoid water leakage. head shower massage jet massage jet hand shower volume controls thermostatic faucet 1.5m stainless steel hose massage jet spout Technical data Minimum working pressure 11.6 PSI Maximum working pressure 72.
PAGE 5
Thermostatic valve removal and installation Remove process 1 Take off cap 2 Loosen HEX screw off with allen 3 Take off head wrench 4 Take off plastic ring 5 Position on the golden ring and pull out 6 Remove the valve the valve by needle nose pliers Installation process 1 Place valve in place(ensure the screw head pointing to the cut off of the plated ring) 4 Press the button on the head and put on the head as below ensuring the screw hole pointing to the front 2 Put golden ring 3 Put plastic ring