Installation Instructions

INSTALLATION

INSTRUCTIONS

Single hole faucet

Cleaning

Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.

Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator

and tighten.

Aerator

FFT1045BN

●

We recommend that this product is installed by a qualified professional contractor.

●

Please check this product immediately to ensure that it has not been damaged and is complete.

●

Please flush the water system to ensure that no debris or any other impurities can enter the taps.

Turn off water supply before commencing work

● Please read these instructions carefully and keep for future reference.

Important

PAGE 1
INSTALLATION INSTRUCTIONS FFT1045BN Single hole faucet Important We recommend that this product is installed by a qualified professional contractor. ● Please check this product immediately to ensure that it has not been damaged and is complete. ● Please flush the water system to ensure that no debris or any other impurities can enter the taps. ● Turn off water supply before commencing work. ● Please read these instructions carefully and keep for future reference.
PAGE 2
Dimensions 5 5/8″ Unit:inches 12 5/8″ 4 5/8″ Max 1.1″ 7 5/8″ 4 3/8″ Installation HANDLE CARTRIDGE COVER RETAINING NUT GRUB CAP SCREW FAUCET CARTRIDGE PEDESTAL SUPPLY LINES FAUCET WASHER To remove the cartridge. RUBBER WASHER PLASTIC WASHER FEMALE SCREW HEAD SCREW First shut off the water supply to the tap. 1: Pull out the cap from the handle. 2: Loosen the grub screw in handle, but do not remove it. 3: Take off the handle, unscrew the cartridge cover. 4: Unscrew the retaining nut.