Instructions / Assembly

Installation Instructions

Models C with Rope & Pull Kit

STEP 1

Cut the roll of self-adhesive hook & loop into 3 strips, two lengths equal to the height of the

door jambs, and one long strip for the header.

STEP 2

Install and align the self-adhesive hook & loop strips on both door jambs about 1” in front

(street side) of the door stops/weather strips. Next add the hook & loop strip to the header, so

that is allows a smooth surface edge with both door jamb strips.

STEP 3

Starting at either upper corner, attach the screen to the hook & loop strip which is mounted

already on the header. Next attach the screen to the hook & loop strips that are mounted on

either of the door jambs of the garage door.

STEP 4 Attach cleat to the door jamb between garage door and screen, about 5’ high on

whichever side willing to pull from, and using wood screws.

Not Included

 Hammer and Step Ladder

 5/8” Roofing Nails (Optional for Step 8)

 ¾” plastic pipe cut to width of screen (Step 5)

Included

 One roll of self-adhesive hook & loop

 3 Mounting brackets

 4 Eyelets

 3 Cords (Each different lengths)

 1 Cleat

 8 Wood Screws

PAGE 1
Installation Instructions Models C with Rope & Pull Kit Not Included Included       One roll of self-adhesive hook & loop 3 Mounting brackets 4 Eyelets 3 Cords (Each different lengths) 1 Cleat 8 Wood Screws    Hammer and Step Ladder 5/8” Roofing Nails (Optional for Step 8) ¾” plastic pipe cut to width of screen (Step 5) STEP 1 Cut the roll of self-adhesive hook & loop into 3 strips, two lengths equal to the height of the door jambs, and one long strip for the header.
PAGE 2
STEP 5 Install eye screws. All 4 eye screws should go into the header on the inside of the screen approximately 1” away. Eye Screw 1- Place in center of header. (Equally centered from both sides of garage opening.) Eye Screw 2- Screw into header 12” from the end of the header furthest away from the cleat. Eye Screw 3- Screw into header 12” from the end of the header closest to the cleat. Eye Screw 4- Place within 6” from same side as cleat.