Installation Guide

Installation Instructions

ROPE AND PULL KIT FOR MODEL D

WHAT YOU WILL NEED:

INCLUDED:

• 1 FRESH AIR SCREEN

• 1 ROLL OF SELF-ADHESIVE LOOP STRIP

• MOUNTING BRACKETS (4 IN A SMALL KIT, 6 IN A LARGE KIT)

• EYELETS (6 IN A SMALL KIT, 8 IN A LARGE KIT)

• CORDS (4 IN A SMALL KIT, 6 IN A LARGE KIT | EACH WILL BE IN DIFFERENT LENGTHS)

• WOOD SCREWS (12 IN A SMALL KIT, 16 IN A LARGE KIT)

• 2 CLEATS

NOT INCLUDED:

• HAMMER

• PHILIPS SCREWDRIVER

• STEP LADDER

• 5/8" ROOFING NAILS (OPTIONAL FOR STEP 4)

• 3/4" PIPE (PVC RECOMMENDED) CUT TO THE WIDTH OF THE SCREEN (STEP 5)

PAGE 1
Installation Instructions ROPE AND PULL KIT FOR MODEL D WHAT YOU WILL NEED: INCLUDED: • • • • • • • 1 FRESH AIR SCREEN 1 ROLL OF SELF-ADHESIVE LOOP STRIP MOUNTING BRACKETS (4 IN A SMALL KIT, 6 IN A LARGE KIT) EYELETS (6 IN A SMALL KIT, 8 IN A LARGE KIT) CORDS (4 IN A SMALL KIT, 6 IN A LARGE KIT | EACH WILL BE IN DIFFERENT LENGTHS) WOOD SCREWS (12 IN A SMALL KIT, 16 IN A LARGE KIT) 2 CLEATS NOT INCLUDED: • • • • • HAMMER PHILIPS SCREWDRIVER STEP LADDER 5/8" ROOFING NAILS (OPTIONAL FOR STEP 4) 3/4" PIPE (
PAGE 2
Use steps 1-4 to install your Fresh Air Screen. Use Steps 5-8 to install the Rope and Pull Kit. If you already have a Fresh Air Screen installed, skip to step 5. STEP 1 Measure the height of the door jambs and the length of the header. Cut the self-adhesive loop roll into three strips equal to those measurements. STEP 2 Apply the Self-Adhesive Loop. • Select an adhesive loop strip that was measured and cut for the door jambs in step 1.
PAGE 3
• Long Cord #1- Insert the knotted end into the bracket across from Eye Screw 1. Run the cord down the screen, then back up to Eye Screw 1. Run the cord through Eye Screws 1, 3, and 5, and down to the cleat. • Long Cord #2- Insert the knotted end into the bracket across from Eye Screw 2. Run the cord down the screen, then back up to Eye Screw 1. Run the cord through Eye Screws 2, 4, &6, and down to the cleat.