Instructions / Assembly

Installation Instructions

Models D with Rope & Pull Kit

STEP 1

Cut the roll of self-adhesive hook & loop into

3 strips, two lengths equal to the height of

the door jambs, and one long strip for the

header.

STEP 2

Install and align the self-adhesive hook & loop strips on both door jambs about 1” in front

(street side) of the door stops/weather strips. Next add the hook & loop strip to the header, so

that is allows a smooth surface edge with both door jamb strips.

STEP 3

Starting at either upper corner, attach the screen to the hook & loop strip which is mounted

already on the header. Next attach the screen to the hook & loop strips that are mounted on

either of the door jambs of the garage door.

STEP 4 Attach cleat to the door jamb between garage door and screen, about 5’ high on

whichever side willing to pull from, and using wood screws.

STEP 5

Install eye screws. All eye screws should go into the header on the inside of the screen

approximately 1” away.

Eye Screw 1&2- Place one on each side, 6’’ from center zipper

Eye Screw 7&8 (Large Kit only) Place one on each size of the screen, 1/3 of the length away from

each end of the screen.

Eye Screw 3&4- Place one on each side, 12” in from outside zipper

Eye Screw 5&6- Place one on each side, 6” from outside zipper

STEP 6

Attach brackets to the header (street side) across from eye screws 1, 2, 3, and 4 (also across

from eye screws 7 and 8 for large rope and pull kits)

Not Included

• Hammer and Step Ladder

• 5/8” Roofing Nails (Optional for Step 8)

• ¾” plastic pipe cut to width of screen (Step 5)

Included

 Small  Large

• One roll of self-adhesive hook & loop

• Mounting brackets (Small kit – 4, large kit -6)

• Eyelets (Small kit – 6, large kit -8)

• Cords (Small kit – 4, large kit -6)

• (Each different lengths)

• 2 Cleat

• Wood Screws (Small kit – 12, large kit -16)

PAGE 1
Installation Instructions Models D with Rope & Pull Kit Included  Small • • • • • • •  Large One roll of self-adhesive hook & loop Mounting brackets (Small kit – 4, large kit -6) Eyelets (Small kit – 6, large kit -8) Cords (Small kit – 4, large kit -6) (Each different lengths) 2 Cleat Wood Screws (Small kit – 12, large kit -16) Not Included • • • Hammer and Step Ladder 5/8” Roofing Nails (Optional for Step 8) ¾” plastic pipe cut to width of screen (Step 5) STEP 1 Cut the roll of self-adhesive hook &
PAGE 2
STEP 7 Insert the cords accordingly: Long Cord #1- Insert the knotted end into the bracket across from Eye Screw 1. Run the cord down the screen, then back up to Eye Screw 1. Run the cord through Eye Screws 1, 3, and 5, and down to the cleat. Long Cord #2- Insert the knotted end into the bracket across from Eye Screw 2. Run the cord down the screen, then back up to Eye Screw 1. Run the cord through Eye Screws 2, 4, &6, and down to the cleat.