MC55240MD MC55240MDS MC55240MDB
Contents Safety and warning information…........2 Installing your new appliance………....8 Description of the appliance.................9 Reversing the door............…..........10 Operation.............……….…...............13 Using your appliance.…….…..........14 Helpful hints and tips……….…........16 Cleaning and care.....……………….17 Troubleshooting......…………………19 Disposal of the appliance.......…..
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Keep all packaging away from children as there is risk of suffocation. If you are discarding the appliance, pull the plug out of the socket, cut the connection cable (as close to the appliance as you can) and remove the door to prevent children playing from suffering an electric shock or from closing themselves inside it.
WARNING — The refrigerant and insulation blowing gas are flammable. When disposing of the appliance, do so only at an authorized waste disposal centre. Do not expose to flame. WARNING —When positioning the appliance, ensure the supply cord is not trapped or damaged. WARNING —Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance. The symbol is a warning and indicates the refrigerant and insulation blowing gas are flammable.
It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a shortcircuit, fire, and/or electric shock. Electrical safety 1.The power cord must not be lengthened. 2. Make sure that the power plug is not crushed or damaged. A crushed or damaged power plug may overheat and cause a fire. 3. Make sure that you can access the main plug of the appliance. 4. Do not pull the main cable. 5. If the power plug socket is loose, do not insert the power plug.
Do not place food products directly against the air outlet on the rear wall. Store pre-packed frozen food in accordance with the frozen food manufacture’s instructions. The appliances manufactures storage recommendations should be strictly adhered to.Refer to relrelevant instructions for storage. Do not place carbonated or fizzy drinks in the freeze compartment as it creates pressure on the container,which may cause it to explode,resulting in damage to the appliance.
Before maintenance, switch off the appliance and disconnect the mains plug from the mains socket. Do not clean the appliance with metal objects, steam cleaner, ethereal oils, organic solvents or abrasive cleansers. Do not use sharp objects to remove frost from the appliance. Use a plastic scraper. Installation Important! For electrical connection carefully, follow the instructions given in this manual. Unpack the appliance and check if there are damages on it.
In order to improve efficiency of the cooling system and save energy, it is necessary to maintain good ventilation around the appliance for the dissipation of heat. For this reason, sufficient clear space should be available around the refrigerator. Suggest :It is advisable for there to be 50-70mm of space from the back to the wall, at least 100mm from its top,at last 100mm from its side to the wall and a clear space in front to allow the doors to open 135°. As shown in following diagrams.
Description of the appliance View of the appliance (RD-31DC4SLA/CPA1-001) 1.Refrigerator lamp 2.Door switch 3.Shelf 4.Vegetable drawer cover 5.Vegetable drawer 6.Serving tray 7.Freezer upper drawer 8.Freezer lower drawer 9.Adjustable foot 10.Egg rack(inside) 11.Upper rack 12.Middle rack 13.Water storage box part 14.Refrigerator door 15.Lower rack 16.Freezer door Fridge Freezer View of the appliance ((RD-31DC4SH A/CPA1-001) 1.Refrigerator lamp 2.Door switch 3.Shelf 4.Vegetable drawer cover 5.
Reversing the door 2. Use a putty knife or thin-blade screwdriver to prize the screw hole cover which is at the top left corner of the refrigerator, and the upper hinge cover which is at the top right corner of the refrigerator. upper hinge cover (right) screw hole cover 3. Unscrew the special flange selftapping screws which are used for fixing the right upper hinge part by a 8mm socket driver or a spanner (please support the upper door with your hand when doing it) .
8. Place the lower door on a smooth surface with its panel upwards. Loose screw ② and part ①, then Install them to the left side and tighten securely. ① Stop block ② Self-tapping screw 6. Place the upper door on a smooth surface with its panel upwards. Loose screw ② and part ①, then Install them to the left side and tighten ① ② ① Stop block ② Self-tapping screw ① ② 9. Change screw hole covers on middle cover plate from left to right (as shown in figure below). screw hole covers 7.
11.Replace the lower hinge part to the left side and fixing it with the special flange self-tapping screws. Replace the adjustable bottom feet parts to another side and fixing it. 12.Transfer the lower door to the property position, adjust the lower hinge part, make the hinge axis into the lower hole of the lower door, then tight the bolts. 15.
Operation Starting up and temperature regulation Changing the light bulb Insert the plug of the connection lead into the plug socket with protective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on.After the fridge has been placed in position,wait for 5 minutes before electricity is supplied.Don't store anything until the temperature inside the fridge becomes low enough.
Accessories 1) Movable shelves/trays Various glass, plastic storage shelves or wire trays are included with your appliance-different models have different combinations and different models have different features. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Install the door shelf s pre wa s in rdly Firstly tilt the left side of the door shelf , and make sure the notch has been fastened to the door .
Accessories 2) It is only applicable to RD-31DC4SLA/CPA1 Water Dispenser The water dispenser, located in the fridge door, is for storing drinking water. With this appliance you can obtain chilled water easily without opening the refrigerator. You should review of following tips. Dispenser Pad Assembling Before assembling, please drain the water inside the tank, and check whether the washer reversed or not. 1. Insert the head into the hole. 2. Fit the tank along the guides on the door. 3.
Other beverage(milk,juice, carbonated beverage etc) is not suggestted to be used than potable water.Especially beverage including grain must not be used (may result in failure). ● Hot water can not be filled into the water tank directly. ● Warning! Don't touch other parts of the appliance when filling water, it may cause the water leakage. Receiving Water You should use the correct cups to receive water underneath the water dispenser.
film wrap. Milk bottles: Should have a lid and be stored in the door racks. Hints for freezing ● When first starting-up or after a period out of use, let the appliance run at least 2 hours on the higher settings before putting food in the compartment. ● Prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible to subsequently thaw only the quantity required.
long. If the frost is too thick, choose a time when the supply of food stocks are low and proceed as follows: 1.Remove existing food and accessories baskets, unplug the appliance from the mains power and leave the doors open. Ventilate the room thoroughly to accelerate the thawing process. 2. When defrosting is completed, clean your freezer as described above. Caution! Don't use sharp objects to remove frost from the freezer compartment.
Troubleshooting If you experience a problem with your appliance or are concerned that the appliance is not functioning correctly, you can carry out some easy checks before calling for service, please see below. You can carry out some easy checks according to this section before calling for service. Warning! Don't try to repair the appliance yourself.
Ensure food is placed within the appliance to allow sufficient A layer of frost occurs in the compartment Temperature inside is too warm Temperature inside is too cold Doors cant be closed easily Water drips on the floor The light is not working ventilation. Ensure that door is fully closed. To remove the frost, please refer to cleaning and care chapter.
FRIDGEMASTER Unit 2 Meadow Court Millshaw Lane Leeds, West Yorkshire, LS11 8LZ, United Kingdom
