Wi-Fi Operation Manual
Table Of Contents
- INTRODUCTION
- IMPORTANT SAFETY INFORMATION
- PERSONAL INJURY OR DEATH HAZARDS
- FCC Caution
- Kuhl, Kuhl Q, And Wallmaster Controls
- KUHL, KUHL Q, AND WALLMASTER
- Wi-Fi SET UP INSTRUCTIONS
- Wi-Fi TROUBLESHOOTING TIPS
- FA Pro/ FA Premier App Info
- FA Pro, FA Premier Troubleshooting
- Chill Premier/ Unifit App Info
- Chill Premier/ Unifit Registration
- Chill Premier/ Unifit Login
- Chill Premier/ Unifit Troubleshooting
12 PB
FRIEDRICH CONNECT
KUHL, KUHL Q, AND WALLMASTER
Wi-Fi TROUBLESHOOTING TIPS
If you received this error message
“Error in association process: Request has been terminated Possible causes: the network
is ofine, Origin is not allowed by Access-Control-Allow-Origin, the page is being unloaded,
etc.”
This means your Wi-Fi (internet connect) has gone off online.
Check your Wi-Fi signal strength, reconnect service to your router or restart your router
depending on your internet services.
Reset your Air Conditioning unit by turning off the power and then unplugging the unit for a
minimum of 5 seconds.
Log back into your account and restart the set up process.
If you are on the last step where it states
“Looking for recently added device. It will appear in the list when ready. Please wait , this
may take up to 3 minutes. Then a message pops up below that states “Unable to nd device.
Please double check the WI-FI SSID and password and try again”.
This means the consumer has entered the wrong WI-FI network name (SSID) or password.
Reset your Air Conditioning unit by turning off the power and then unplugging the unit for a
minimum of 5 seconds.
Log back into your account and restart the set up process.
For More information visit Friedrich.com