DWC1 Thermostat Installation and Operations Manual

10 DWC1 Programmable Thermostat
Installation instruction
Function Code Set
Press button to start.
3
During the test run, pressing the below
button will exit the test run.
- Select operation, temperature
up/down, wind flow control, wind
direction, start/stop button.
4
Long press button for 3 seconds, it
enters into remote controller setting
mode.
- Press button with a short press,
controller enters user set up mode. To
ensure set up mode user may need to
press button for 3 seconds.
1
Setup figure '01' blinks at the lower part
of indication window.
2
Installer Setting - Test Run Mode
After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.