DWC1 Thermostat Installation and Operations Manual

20 DWC1 Programmable Thermostat
Installation instruction
If pressing button long for 3
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
1
Function Code Zone Number installed
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
5
Repeat pressing button to select
Function code 14.
Ex) Setting the Zone Number for "2"
2
Select Zone Number by pressing
button
(02~04 : number of zone installed)
3
Press button to save or release.
4
Installer Setting - Zone Number Setting
This function is only available on some products.
Zone Number is to set the number of installed zones. It's possible to control only in zone new type