DWC1 Thermostat Installation and Operations Manual

Owner’s & Installation Manual 5
ENGLISH
Installation instruction
2
2
1
3
3
1. Once mounting location has been located please ensure screws are installed
properly and are tight.
- Install base of controller flush against the wall, ensure that no warping of base otherwise controller operation
may be affected.
2. DWC1 can be installed with the cable in multiple directions.
- Setup directions: Route cable through electrical wall box, top-right or far right-side.
- If setting up DWC1 cable into the top right and far right-side, please do this after removing the plastic
breakaway piece.
Reclamation to the surface of the wall
Upper part guide groove
Right part guide groove
Installation instruction
Breakaway locations for cable routing