Installation Manual 24CJ

18
ENGLISH
CAUTION
Provide the circuit breaker between power
source and the unit as shown by
!
10±3mm
20mm
GN/YL
AWG_“A”
10±3mm
20mm
GN/YL
AWG_“B”
The power connecting cable connected to the
indoor and outdoor unit should be complied
with the following specifications (UL
recognized or CSA certified).
Power
Capacity(Btu/h)
24k
"A" 12
Connecting
Cable
Capacity(Btu/h)
24k
"B" 18
Connecting cable
Power supply cable
Outdoor unit
- Connect the wires to the terminals on the
control board individually.
- Secure the cable onto the control board with
the cord clamp.
- Use a recognized circuit breaker between
the power source and the unit.
A disconnecting device to adequately
disconnect all supply lines must be fitted.
*The feature can be changed according a type
of model.
Outdoor unit
Terminal block
Over 5mm
(0.2")
Cover control
Conduit panel
Connecting
cable
Power supply
cord
1(L1) 2(L2) 1(L1) 2(L2) 3
Circuit Breaker(A)
Capacity(Btu/h)
24k
25
Air
Conditioner
Main power source
Circuit Breaker
Use a circuit breake
or time delay fuse.