Multi Zone Service Manual - General

- 20 -
Only for training and service purposes
Part 2 Functions & Controls
5.4 Child Lock Function
5.5 Forced operation
• To operate the appliance by force in case when the remote control is lost, the forced operation selection switch is on
the main unit of the appliance, and operate the appliance in the standard conditions.
• The operating condition is set according to the outdoor temp. and intake air temperature as follows.
• The unit select the last operation mode in 3 hours.
• Operating procedures when the remote control can't be used is as follows :
- The operation will be started if the ON/OFF button is pressed.
- If you want to stop operation, re-press the button.
Indoor temp.
over 76°F(24~25°C)
70~76°F(21~24°C)
below 70°F(21°C)
Setting temp.
72°F(22°C)
72°F(22°C)
72°F(22°C)
Setting speed of
indoor fan
High speed
Operating Mode
Cooling
Healthy Dehumidification
Heating
It is the function to use preventing children or others from careless using.
TEMP
FAN
SPEED
OPER
MODE
During the operation, when pressing the
button and button for approx. 3 seconds,
the ‘Child Lock’ Function can be used.
-
At the time of initial setting of the ‘Child Lock’,
the ‘CL’ Will be indicated approx. 3 seconds
at the temperature Display section before
resuming to the previous mode.
After the setting of the ‘CL’, if another button
is setup, the button can not be recognized as
the ‘CL’ is indicated at the temperature
display section for approx. 3 seconds.
1
If the ‘CL’ function is wanted to be used
under the operation standby state, press the
button and Button for approx.
3 seconds under the standby mode state and
the system will be the ‘CL’ state.
2
As for the releasing method, when pressing
the Button and button for approx. 3
seconds, the ‘CL’ function can be released.
3
FAN
SPEED
FAN
SPEED
FAN
SPEED