Installation guide

13
Trouble Shooting
●
Has there been a power failure?
●
Circuit breaker tripping?
●
Wires not attached?
●
Unit will not restart after turning
off?
●
Is remote functioning properly?
●
If no- See remote
troubleshooting
●
Wait for 3min, then attempt to
turn on unit. If unit doesn't
restart please call service.
●
Call for immediate service.
●
Call servicer or dealer for
licensed professional.
●
If no check circuit breaker.
●
Wait for power to be restored.
Air conditioner
not operating
Mist/Fog
coming from
indoor unit
discharge
louvers
●
Check indoor temprature
and humidity.
●
Allow unit to run for sometime
Mist/fog should stop once
normal Indoor conditions
stabilize.
Issue
Check items Solution
Cannot adjust
set temprature
●
Unit operating under Auto
mode.
●
Temperature can’t be adjusted
while in Auto mode.
Please change operation
modes if needing to change
set point.
●
Your required temperature
exceeds the set temperature
range.
●
Set temperature range:
61°F-86°F .
Cooling
temprature
and Heating
temprature
not sufficent
●
Brownout conditions occured?
Voltage too low.
●
Wait until power
stabilizes.
●
Is filter dirty?
●
Clean the filter.
●
Set temperature is in proper
range?
●
Adjust temperature to proper
range.
●
Door and window are open?
●
Close door and window.
Allow time for system
to stabilize.
●
Are there lights on the display?