Accessory Installation Manual (2021, 2022)

Model PXCJA

920-119-02 (6-11)

Installation Instructions

CONDUIT KIT with JUNCTION BOX

For Use with Packaged Terminal Units

Please read these instructions completely before attempting installation.

NOTE: ALL ELECTRICAL WORK MUST CONFORM WITH LOCAL CODES AND ORDINANCES. THE

NATIONAL ELECTRICAL CODES, ANSI/NFPA NO. 70-19993 OR CURRENT EDITION, AND IN CANADA,

THE CANADIAN ELECTRICAL CODE PART I, CSA STANDARD C22.1-1993 OR CURRENT EDITION.

PDE or PDH MODELS

To install the line voltage power leads and conduit to chassis, follow the instructions below

and refer to Figures on following pages. PXCJA Conduit Kit is required with this setup.

1. Remove chassis’s front panel to expose the unit’s junction

box (Fig 1). Remove all 6 screws to junction box assembly.

Fig 1

PAGE 1
Model PXCJA Installation Instructions CONDUIT KIT with JUNCTION BOX For Use with Packaged Terminal Units Please read these instructions completely before attempting installation. NOTE: ALL ELECTRICAL WORK MUST CONFORM WITH LOCAL CODES AND ORDINANCES. THE NATIONAL ELECTRICAL CODES, ANSI/NFPA NO. 70-19993 OR CURRENT EDITION, AND IN CANADA, THE CANADIAN ELECTRICAL CODE PART I, CSA STANDARD C22.1-1993 OR CURRENT EDITION.
PAGE 2
Model PXCJA 2. Prepare the 265V (or 230V) power cord for connection to the chassis’s power cord connector by cutting the plug head to the appropriate length (refer to Fig 2). Fig 2 3. Route the cut end of power cord through the locknut, spacers, conduit connector, bushing, and flex conduit sleeve on the chassis’s junction box (refer to Fig 3). 4. The lead cut end should pass all the way through the opposite end of flex conduit sleeve into the second bushing then between the elbow connector housing.
PAGE 3
Model PXCJA 6. Connect and join stripped wall electrical wires with harness wires using wire nuts. Twist the incoming ground wire and the green ground wire together (use copper conductors only) and attach to the junction box with the provided ground screw. Fig 5 NOTE: The junction box mounting must comply will all local electrical codes having jurisdiction.