Installation and Operation Manual
27
q Inspect and ensure that all components and accessories have been
installed properly and that they have not been damaged during the
installation process.
q
Check the condensate water drain(s) to ensure they are adequate for
the removal of condensate water, and that they meet the approval of
the end user.
q
Ensure that all installations concerning clearances around the unit
have been adhered to. Check to ensure that the unit air lter, indoor
coil, and outdoor coil are free from any obstructions.
q
Ensure that the entire installation is in compliance with all applicable
national and local codes and ordinances that have jurisdiction.
q
Secure components and accessories, such as the chassis, decorative
front cover and control door.
q
Start the unit and check for proper operation of all components in
each mode of operation. Instruct the owner or operator of this units
operation, and the manufacturer’s recommended routine maintenance
schedule.
NOTE: A log for recording the dates of maintenance and/or service
is recommended.
q
Present the owner or operator of the equipment with the Installation
& Operation manual, all accessory installation instructions, and the
name, address and telephone number of the Authorized Friedrich
Warranty Service Company in the area for future reference if
necessary.
Final Inspection & Start-up Checklist
Routine Maintenance
To ensure proper unit operation and life expectancy the following mainte-
nance procedures should be performed on a regular basis.
however, you must be careful not to bend the aluminium n pack. Use a
sweeping up and down motion in the direction of the vertical aluminium
n pack when pressure cleaning coils.
NOTE: It is extremely important to insure that none of the electrical
and/or electronic parts of the unit get wet. Be sure to cover all electrical
components to protect them from water or spray.
Decorative Front
The decorative front and discharge air grille may be cleaned with a mild
soap or detergent. Do NOT use solvents or hydrocarbon based cleaners
such as acetone, naphtha, gasoline, benzene, etc., to clean the decorative
front or air discharge grilles.
Use a damp (not wet) cloth when cleaning the control area to prevent
water from entering the unit, and possibly damaging the electronic control.
Fan Motor & Compressor
The fan motor & compressor and are permanently lubricated, and require
no additional lubrication.
Wall Sleeve
Inspect the inside of the wall sleeve and drain system periodically (annually
or semi-annually) and clean as required.
Under extreme conditions, more frequent cleaning may be necessary.
Clean both of these areas with an antibacterial and antifungal cleaner.
Rinse both items thoroughly with water and ensure that the drain outlets
are operating correctly. Check the sealant around the sleeve and reseal
areas as needed.
Air Filter
To ensure proper unit operation, the air lters should be cleaned at least
monthly, and more frequently if conditions warrant. The unit must be turned
off before the lters are cleaned.
To remove the air lters, grasp the top of the lter and lift out of the front
cabinet. Reverse the procedure to reinstall the lters.
Clean the lters with a mild detergent in warm water, and allow them to dry
thoroughly before reinstalling.
Coils & Chassis
NOTE: Do not use a caustic coil cleaning agent on coils or base pan.
Use a biodegradable cleaning agent and degreaser. The use of harsh
cleaning materials may lead to deterioration of the aluminum ns or the
coil end plates.
The indoor coil and outdoor coils and base pan should be inspected pe-
riodically (annually or semi-annually) and cleaned of all debris (lint, dirt.
leaves, paper, etc.) as necessary. Under extreme conditions, more frequent
cleaning may by required. Clean the coils and base pan with a soft brush
and compressed air or vacuum. A pressure washer may also be used,
WARNING
Electrical Shock Hazard
Unplug Unit or turn off electrical power
to unit prior to performing maintenance
procedures.
Failure to do so can result in electrical
shock or death.