Installation and Operation Manual
31
New Construction Accessories
PDXDAA
LATERAL DUCT ADAPTER Attaches to the Friedrich PTAC/PTHP unit to direct
up to 35% of the total airow to a second room. The unit mounted duct plenum
features a front mounted aluminum grille that has two positions to provide the
most optimal air direction. The air may be directed to either the left or the right of
the unit through the supplied 3.5 H" x 7 W" x 47" L plenum. Plenum may be cut
to length by the installer. Kit includes duct plenum, front grille, 47" duct extension,
duct discharge grille, duct end cap and all necessary mounting hardware.
PDXDEA
LATERAL DUCT EXTENSION Additional 3.5 H" x 7" W x 47" L plenum for use
with the LATERAL DUCT ADAPTER. A maximum of 3 duct extensions total may
be used. Note: Ducted airow is reduced as duct length is increased.
PXFTA
REPLACEMENT FILTER PACK These are original equipment return air lters.
They are reusable and can be cleaned by vacuuming, washing, or blowing out,
and are sold in convenient ten-packs. (Two lters per chassis).
PXDR10
CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal
draining of condensate or to the rear wall sleeve ange for external draining.
Recommended on all units to remove excess condensate.
Packaged in quantities of ten.
RT6
DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single stage heat
for PDE models or single stage cool, dual stage heat for PDH model thermostat
features high/low fan speed switch. Thermostat is hard wired and can be battery
powered or unit powered. Features backlit display and multiple conguration
modes. For use on PD-series Friedrich PTACs and Vert-I-Paks.
WRT1
DIGITAL THERMOSTAT Wireless, single stage, wall-mounted digital thermostat
with two fan speeds. Features backlit display and multiple conguration modes.
PDXRTA
REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons
that can be placed over the factory control buttons when a remote wall mounted
thermostat is used. The escutcheon directs the guest to the wall thermostat for
operation and retains the LED window to display error codes and diagnostic
information.
FRIEDRICHLINK® ENERGY MANAGEMENT THERMOSTAT Integrated oc-
cupancy sensor uses a combination of motion and thermal sensing technologies
for accurate occupancy detection. Reliable occupancy detection allows saving en-
ergy when rooms are unoccupied. Energy saving presets eliminate the guesswork
and make it easy to adjust the energy saving settings.
EMWRT1 Wireless thermostat with occupancy sensor.
EMRT1 Wired thermostat with occupancy sensor.