Installation and Operation Manual

FRP010

NOTE: Construct wall opening to comply with all applicable building codes.

MAIN STUDS

JACK STUDS

LINTEL

MOUNTING

SCREW HOLES

NO HOLES IN BOTTOM OF WALL

SLEEVE UNLESS DRAIN KIT IS USED

MAIN STUDS

JACK STUDS

5. Drill two 3/16" holes through each side of the sleeve approximately

4" from top and 4" from bottom of sleeve. Screw four #10 x 1"

screws (included) or appropriate fasteners for your installation,

through the holes in the sides of the wall sleeve.

6. Apply sealant around the wall sleeve where it projects through the

inside and outside wall surfaces. Apply the sealant to the screw

heads or the tops of the fasteners used in Step #5.

7. If the chassis and exterior grille are to be installed later, leave the

weatherboard and center support in place, otherwise remove and

dispose of them. (See Figure 13, Page 12).

8. Provide a support lintel if the wall sleeve is installed in a concrete

or masonry wall (See Figure 10, Page 9).

Figure 10

Lintel Installation

One-Piece Deep Wall Sleeve

Installation (PDXWSEXT)

If the wall is thicker than 13 1/4” a deep wall sleeve or wall sleeve extension

MUST be used. The deep wall sleeve may be special ordered through

your Sales Representative.