Manual

920-087-02(9-03)
Section III - ChassisInstallation
* Check to be sure the wall sleeve, extension (if used), grille, and drain kit are installed properly before
chassis installation
1. Remove the weatherboard and center support from
the sleeve (if still in place). Be sure an outdoor grille is
attached.
NOTE: To avoid breaking the door or hinge pins, do not apply
excessive force when installing
_ Pins
Wall sleeve / Control
Door
-- Weatherboard
Center support
Front Panel
3. Remove the two chassis shipping brackets from the ends of
the shipping pallet.
IMPORTANT:Useawa]]sleeveadapterkit(PXSE)if
installinga P-Series chassis in a T-Seriessleeve.
Suffocation hazard
Keep bag away from babies and children.
Do NOT use in cribs, beds or playpens. Destroy
immediately after opening. This oag is NOT a toy.
Failure to do so can result in personal injury end/or death
2. Remove the front cover contained ina protective plastic bag
from chassis. Remove the bag and dispose ofit properly.
If the control door is not installed,follow these steps:
Fromthe front of the cover, slide the right control door pin into
the hole onthe right side of the front cover. Slidethe left door
pin into the hole on the leftside of the front cover opening and
snap it intoplace.
@
Compressor
Chassis
shipping bracket
Shipping pallet
IMPORTANT: When installinga Friedrich P-Series PTAC intoan
existing sleeve, it is important to ensure that the unit is installed
completely. Inspection of the air seal between the condenser air
baffles and aroundthe indoormountingflange isrecommended. In
some cases additional gaskets or baffling may be required.
12