Manual

920-087-02(9-03)
Installation InstructionsModelPXGAStandardGrille
1. Remove the center support and weatherboardifstininstalled
in the sleeve.
2. Insert six plastic grommets into the grille openings from the
outside of the grille as shown in Figure 9.
3. Insert two #8 x 3/8" sheet metal screws (provided) in the top
two outside edge plastic grommets, and tighten them halfway
into the grommets.
4. CAUTION: Bodilyinjury can be caused by grilles falling from
a building during installation. It is recommended that a safety
line be attached to the grille and an anchor point inside the
building durinq installation.
5. Grasp the grille bythe attached plastic handles. Positionit with
the condensate drain knockouts facing down. From insidethe
building, maneuver the grille through the wall sleeve and pull
toward you untilthe screw heads are inserted into the keyhole
slots at the top of the wall sleeve. Tighten the two screws
completely.
6. Insert the remaining screws into the remaining holes and
tighten securely.
Figure 9
Quantity Description
1 Stamped Aluminum Grille
6 Plastic Grommets
6 #8 x 3/8"Sheet Metal Screws
Figure 9
StandardGrille
Waft sleeve
-- Weatherboard
-- Center support
Plastic handles
\
\
Plastic
grommets
10