Installation Manual

29
Accessories
PXAA
New Construction Accessories
PDXWSA
PDXWSEXT18
PDXWSEXT24
PDXWSEXT
WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-
step process, then powder coated with a polyester nish and cured
in an oven for exceptional durability. The wall sleeve is insulated for
sound absorption and thermal efciency, 16" H x 42" W x 13
3
/4" D.
DEEP WALL SLEEVE For walls up to 17
1
/2" D.
DEEP WALL SLEEVE For walls up to 23
1
/2" D.
CUSTOM DEEP WALL SLEEVE One piece extended wall sleeve for walls
from 13
1
/4" to 25
1
/2" D are available by special order.
PXSE
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2
3
/8"
sleeve extension attached to the room side of the sleeve to allow for the
installation of a PZ-Series Friedrich PTAC in a T-Series sleeve.
PXGA GRILLE Standard, stamped aluminium, anodized to resist chalking and
oxidation.
PXAA
PXBG
PXSC
ARCHITECTURAL GRILLES Consist of heavy-gauge 6063-T5
aluminum alloy: 42" W x 16" H x 1
1
/8" D
PXAA – Clear, extruded aluminum
PXBG – Beige acrylic enamel
PXSC – Also available in custom colors.
PXDR10 CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for
internal draining of condensate or to the rear wall sleeve ange for ex-
ternal draining. Recommended on all units to remove excess conden-
sate. Packaged in quantities of ten.
PXCJA CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit with junc-
tion box for 208/230V and 265V units (subbase not required).
Kit includes a means of quick disconnect for easy removal of the
chassis. *Required for 265V installations.
PXFTB
REPLACEMENT FILTER PACK These are original equipment return air
lters. They are reusable and can be cleaned by vacuuming, washing,
or blowing out, and are sold in convenient ten-packs. (Two lters per
chassis).
PXGA
Deep wall sleeve PDXWSEXT18 shown with weather panel
PDXWSA