Service and Parts Manual (2018, 2019, 2020, 2021, 2022)

35 PB
INSTALLATION
PXGA Standard Grille
12
PXGAStandard Grille
Installation Instructions
1. Remove the center support and weatherboard if still installed in
the sleeve.
2. Insert six plastic grommets into the grille openings from the outside
of the grille as shown in Figure 13.
3. Insert two #8 x ⅜" sheet metal screws (provided) in the top two
outside edge plastic grommets, and tighten them half way into
the grommets.
4. Grasp the grille by the attached plastic handles. Position
it with the condensate drain knockouts facing down.
From inside the building, maneuver the grille through the wall
sleeve and pull toward you until the screw heads are inserted
into the keyhole slots at the top of the wall sleeve. Tighten the
two screws completely.
5. Insert the remaining screws into the remaining holes and tighten
securely.
WARNING
Falling Object Hazard
Not following Installation Instructions for
mounting your air conditioner can result
in property damage, injury, or death.
Figure 13
Standard Grille
FRP013
WALL SLEEVE
WEATHERBOARD
CENTER SUPPORT
STANDARD GRILLE
PLASTIC GROMMETS
PLASTIC HANDLES
WALL
SLEEVE
STANDARD
GRILLE
#8 x 3/8”
SHEET METAL
SCREW
Description
Stamped Aluminum Grille
Plastic Grommets
#8 x –" Sheet Metal Screws
Quantity
1
6
6
PXGA Standard Grille